POLYESTER FABRIC (Lt/Med/Heavy)
LIGHT - 1.7 oz. - 94 x 94 - For aircraft with wing loading under 9 lbs per sq/ft. MEDIUM - 2.7 oz. - Heavy/Strong - For aircraft with wing loading of 9 lbs per sq/ft and up.  HEAVY - 2.8 oz. - For extreme use conditions such as aerobatic, military, bush and agricultural aircraft.

POLYESTER PADDING
NON-WOVEN, 45" wide, 3 oz. per yard. Used under fabric on wing leading edge and turtle deck to smooth rough surfaces. .125 thick, compressed to .020 under load.

POLYESTER FINISHING TAPES (Lt/Med)
Bias tapes (weave pattern 45 degrees to the edge) are suggested for installation over compound surfaces such as around wing tips and tail surfaces. Bias tapes will stretch to conform to the required contour without heat shrinking edges or cutting and notching to remove excess fabric. Stretching reduces the width about 35%, therefore 3" will pull to approximately 2" width around a sharp contour, and 2" will pull to approximately 13S" width.

POLYESTER RIB LACE REINFORCING TAPE
A custom woven high strength polyester filament will tape with a paper protected high tack adhesive coating on one side, for quick application and bonding during the rib lacing procedure. Available in 1/4", 3/8" and 1/2" widths. Also available without the adhesive coating for use as wing inter-rib bracing tape.

CREPE PAPER MASKING TAPE
3M #Y231. The most solvent resistant crepe paper type available. Recommended for the majority of the non-critical masking on a paint job.

CLOTH ANTI-CHAFE / MASKING TAPE
A white rubber based adhesive on cotton cloth. 1" wide, 60 yard rolls. Recommended as the best choice for masking and smoothing sharp metal edges, rough joints and all sharp corners under the fabric covering.

PROPYLENE MASKING TAPE
3M #218 Fine Line. 4.5 mils thick. The best choice by test for paint stripper masking and paint trim line masking. Most solvent resistant masking tape available for clean trim lines with no edge bleed. No crepe paper imprint on fresh finishes.

POLYESTER RIB LACING CORD
Two styles of lacing cord are available, both impregnated with microcrystalline fungicidal wax and packaged 500 yards per spool.
  
1 ) Standard round 4 ply, .035 dia., 60 Ibs. tensile strength.
  
2) Flat braided cord, .012 thick x approximate .080 width, 50 Ibs. tensile strength. Recommended when the minimum rib cord protrusion is desired.

POLYESTER MACHINE SEWING THREAD
10 Ibs. tensile strength, 4 ply thread.
Packaged 500 yd. per spool.

POLYESTER HAND SEWING THREAD
15 Ibs. tensile strength, 3 ply uncoated thread. Packaged 250 yards per spool.